FRITZ!Box 7390 – Service - Knowledge Base

FRITZ!Box 7390 – Service

Loading the factory settings of your radiator control

You can use the "MENU" button to load the factory settings of your radiator control, FRITZ!DECT 300 or Comet DECT.

Note:The configuration procedure and notes on functions given in this guide refer to the latest FRITZ!OS for your FRITZ!Box.

1 Deregistering the radiator control

  1. Click "Home Network" in the FRITZ!Box user interface.
  2. Click "Smart Home" in the "Home Network" menu.
  3. Delete the device you would like to load the factory settings for. To do so, click the corresponding (Delete) button.

2 Restarting the FRITZ!Box

Some of the radiator control's settings may remain intact after deregistering it from the FRITZ!Box. Therefore, restart the FRITZ!Box to delete all settings:

  1. Click "System" in the FRITZ!Box user interface.
  2. Click "Backup" in the "System" menu.
  3. Click on the "Restart" tab.
  4. Click the "Restart" button.

3 Loading the factory settings

  1. Press the "MENU" button on the radiator control.
  2. Use the setting wheel on the radiator control to select the menu item "RES" and then push the "OK" button.
  3. Wait until "OK" flashes in the display and then press the "OK" button.
    • "OK" is shown in the display.

Now the radiator control will restart. The restart will take about two minutes. Afterwards all data and settings are deleted and you can register the radiator control with the FRITZ!Box again.